Make a portable Ipod speaker

It is a portable lightweight, and simple and easy to make. It uses almost everyday objects.

This speaker is going to be a portable speaker with lights that goes up to the volume of about an Itouch speaker.

For this speaker you will need:

1. battery holder

2. spare wire

3. needle nose pliers

4. box (such as small jewlery box)

5. two LED's (radio shack or from spare unused toys.)

6. card that "talks" when you open it.

7. tape / solder if you want.

8. old earphones

9. thin plastic clear sheet

To View All Steps on one page,

Go Pro Today!

step 1First step

Take apart the "singing /  talking" card. You will find a speaker with a circuit board. Use your needle nose pliers to cut the speaker wires at the base near the circuit bo…

step 2second step

This is tricky , take your earphones and cut off the tiny speakers. Then strip the black wires. you should find two fragile wires inside. These are your positive and negati…

step 3Third step

Now, time for the lighting! I decided to use aligator clips for this but you dont have to. I was too lazy to bring out the old soldering gun. As you see in the  picture, I …

step 4Final step

Finally, assemble it all. And you have it finished! Put two holes in the two corners, or where ever you want the lights to go. then just hook up the battery when you want t…

Go to the above webpage for full Article or Back to Portable Audio Video