Subscribe
 

Newest Projects from your Favorite Blogs

Newest Projects automatically updated every Fifteen minutes.
Google
Electronics Infoline Web





DIY Glue Gun Build

DIY Glue Gun Build

Ben Heck uses glue guns alot to put things together. They sure do a good job of quick and dirty strain relief and fixing things in place quickly. With a bit of heat from a big fat soldering iron (one that isnt used for soldering wires) you can easily release things that were previously glued together.

Published: December 12th, 2013

Reverse Engineering the iPod Nano 6 LCD

Reverse Engineering the iPod Nano 6 LCD

mikeselectricstuff gives us a one hour video describing how he goes about reverse engineering.   He was trying to see how easy it would be to use the tiny LCD displays which are normally used in the iPod Nano 6.

Published: December 12th, 2013

VFD Clock

VFD Clock

Our friend Pyrofer wrote in about his new VFD Clock. It sets itself via NTP and adjusts for daylight savings time so no buttons and it never needs adjusting.

Published: December 12th, 2013

Internet Controlled Power Outlet using a Raspberry Pi

Internet Controlled Power Outlet using a Raspberry Pi

Jack Minardi hacked a remote control to allow it to be controlled by an electronic signal rather then a push button. This remote allows him to take control over the remote that can turn on 110 volt outlets.

Published: December 12th, 2013

Ultrasonic Range Finder with Haptic Feedback called The Bat Hat

Ultrasonic Range Finder with Haptic Feedback called The Bat Hat

Jeff Buswell, Clifford Chou and Andrew Knauss from Cornell university made a cool Ultrasonic Range Finder with Haptic Feedback called The Bat Hat for their ECE 4760: Final Project.

Published: December 5th, 2013

Friction Heater used to Heat a House

Friction Heater used to Heat a House

oilpiggy is heating his 1200 square foot house with his home made friction heater. The heater is simply located in a central area at this time and it naturally radiates heat to the house.

Published: December 5th, 2013

Levitating Spinning LEDs

Levitating Spinning LEDs

Sam writes. An electromagnet levitates a ring of LEDs attached to a coil. The LEDs are powered using a wireless power transfer from another coil under the electromagnet.

Published: December 5th, 2013

Arduino based Bike Shock Project Allows the Shock to be Programmable

Arduino based Bike Shock Project Allows the Shock to be Programmable

Lots of things are programmable these days. If you hop into most modern cars you will see switches for things like ride comfort, traction control, performance style etc.

Published: December 5th, 2013

Rechargeable Waterproof Bottle Lamp

Rechargeable Waterproof Bottle Lamp

  When the power fails you could look for the candles that are tucked away in the kitchen drawer, but why not have a Rechargeable Waterproof Bottle Lamp on standby? ASCAS mounted a charging jack and switch to the lid of a medium sized jar, this is connected to a battery and a 3 watt LED.

Published: November 28th, 2013

Hard Disk Clock by Martin Stromer

Hard Disk Clock by Martin Stromer

Martin Stromer made a great looking Hard Disk Clock that is actually very easy to read and looks like a great art piece at the same time. It is based around the ATMega16 Microcontroller.

Published: November 28th, 2013


<< Previous  1  2  3  4  5  6  7  8  9  10  11  Next >>