Subscribe
 


The Big-E Stereo Parabolic Microphone



The Big-E Stereo Parabolic Microphone
Related Videos

This device is a stereo amplifier for a high sensitivity stereo parabolic microphone. It can be used for listening to distant sounds. This unit has a stereo audio path that helps produce more realistic sounding audio. It can be used with headphones or as an audio source for a stereo tape recorder or a PC sound card.

This circuit also works nicely as a remote stereo audio receiver for accompanying a video surveillance system. It is capable of operating on the end of a four wire shielded cable that is more than 100 feet long. For remote operation, a set of inexpensive amplified PC speakers can be connected to the outputs for monitoring the sound.

Specifications
Operating Voltage: 9-15V (9V Nominal) DC
Operating Current: 7ma at 9V DC

Theory
The circuit consists of two identical audio channels and some basic power supply filtering components. Only the left channel will be described. The mini condenser microphone converts sounds into an electrical signal. Resistor R1 provides bias for the condensor microphone's internal amplifier transistor. The 2N3906 PNP transistor acts as a low noise microphone input amplifier. The 10K gain potentiometer is used for adjusting the audio signal level. A stereo 10K audio taper pot can be used for adjusting both channels simultaneously, or individual 10K trimmers can be used for fixed gain applications. The preamp output signal is fed into the 1458 op-amp, which boosts the audio to a level that is sufficient for driving an 8-ohm headphone or a tape recorder input. The 1458 amplifier stage is fixed gain (10X) in the inverting configuration, it drives the headphone speakers.

Capacitor C9 provides DC isolation from the 1458 op-amp output, which sits at half of the supply voltage. Resistor R13 provides impedance protection for the op-amp output and reduces audio distortion when driving low impedance headphones.

DC bias for the 1458 op-amps is set at half of the supply voltage by the R16/R17 voltage divider. Capacitors C13 and C14 filter the DC power supply for the op-amp stage. The DC is further filtered for the input preamp transistors through resistor R15 and capacitor C11. Diode D1 and resistor R18 protect the circuit from reverse battery polarity.

Authored by G. Forrest Cook at FCs Electronic Circuits, Added: 22 Dec 2006




http://www.solorb.com/elect/misc/bige/

Unsorted Pool