Let me first start off by saying this is a wall charger for your ipod shuffle and i have taken the time to make very easy to understand diagrams for everyone, originally the german pinout diagram for the 3.5mm mini jack is well just very basic.
So i have shown everything you need to know and where it should go.
THIS ONLY WORKS FOR THE iPod Shuffle 2nd Generation ClamShell - the only working way i know of besides the mintyboost, but far simpler in design and no battery operated.
Parts List
1 4-connection 3.5mm mini jack
1 Male Type A USB cable
1 Female Type A USB connector
1 +5VDC Voltage Regulator (RadioShack #276-1770)
1 Project enclosure (RadioShack #270-1801)
1 General purpose PC Board (RadioShack #276-149)
1 (>or=)8v AC/DC charger (find this at home) – not more than 12v
1 Pack of 15k Resistors
Tools:
DMM (Digital MultiMeter) or Equivalent – must have
Soldering Iron
Solder
Wire (28 gauge) – might need it
Screwdriver
Flux (not required)
Electrical tape
http://farm1.static.flickr.com/157/392172836_49bcdc6790_m.jpg
http://www.microhaxo.com/hack/
