Organize and Share your Electronics the way you want. Sign-Up for a free account now. It takes only 30 seconds!

Empty Water Detector

Empty Water Detector

This project is an empty water detector to tell you when the water is gone from a vessel originally, I designed it for a christmas tree, but it will work for your dogs water bowl or just about anything else.
Parts list
220k Resistor
Small Perfboard
2N3906 Transistor
2x or 3x AA Battery holder
3mm Red LED
Extra wire for the probes
First, gather all your materials. If you’ve ordered the kit from Gadget Gangster, your project will come with a halfboard – put the halfboard in your vice, as shown in the picture. You’ll also need a soldering iron and 2 AA batteries
Add the resistor from M3 to N7.
Bend out the leads on the other side of the board, flip the board over and solder the resistor down, and trim off the excess wire

Visit Here for more.

 

More Articles to Read

Estimating Power for ADSP-BF561 Blackfin® Processors
Estimating Power for ADSP-BF561 Blackfin® Processors
Teach Your Arduino to Switch Itself Off!
Teach Your Arduino to Switch Itself Off!
Control a tracked robot with your mind (or joystick)
Control a tracked robot with your mind (or joystick)
A 400W (1kW Peak) 100A electronic load using linear MOSFETs
A 400W (1kW Peak) 100A electronic load using linear MOSFETs
Shirt Pocket Transceiver with the Si5351 and OLED
Shirt Pocket Transceiver with the Si5351 and OLED
All metal C930e webcam
All metal C930e webcam
The Soldering Tools That Make Your Life Easier
The Soldering Tools That Make Your Life Easier
App note: Operation evaluation of ultra low ON resistance MOSFET supporting quick charge for 1 c ...
App note: Operation evaluation of ultra low ON resistance MOSFET supporting quick charge for 1 cell Lithium ion battery protection
Synthesized Sidetone
Synthesized Sidetone
App note: Application precautions: Power MOSFET application notes
App note: Application precautions: Power MOSFET application notes

Top




Shares