Browse over 10,000 Electronics Projects using the Page Numbering provided at the bottom of each Page.

iPod Shuffle 2nd Generation AC/DC Wall Charger

iPod Shuffle 2nd Generation AC/DC Wall Charger

Let me first start off by saying this is a wall charger for your ipod shuffle and i have taken the time to make very easy to understand diagrams for everyone, originally the german pinout diagram for the 3.5mm mini jack is well just very basic.
So i have shown everything you need to know and where it should go.

THIS ONLY WORKS FOR THE iPod Shuffle 2nd Generation ClamShell – the only working way i know of besides the mintyboost, but far simpler in design and no battery operated.

Parts List
1 4-connection 3.5mm mini jack
1 Male Type A USB cable
1 Female Type A USB connector
1 +5VDC Voltage Regulator (RadioShack #276-1770)
1 Project enclosure (RadioShack #270-1801)
1 General purpose PC Board (RadioShack #276-149)
1 (>or=)8v AC/DC charger (find this at home) – not more than 12v
1 Pack of 15k Resistors

Tools:
DMM (Digital MultiMeter) or Equivalent – must have
Soldering Iron
Solder
Wire (28 gauge) – might need it
Screwdriver
Flux (not required)
Electrical tape
http://farm1.static.flickr.com/157/392172836_49bcdc6790_m.jpg

Visit Here for more.

 

More Articles to Read

avatar
EEWeb
avatar
Dangerous Prototypes
avatar
EEWeb
avatar
Arduino Blog
avatar
Arduino Blog
avatar
Ken Shirrif
avatar
Dangerous Prototypes
avatar
EEWeb
avatar
Arduino Blog
avatar
Freetronics
avatar
Arduino Blog
avatar
Dangerous Prototypes

Top




Shares