Organize and Share your Electronics the way you want. Sign-Up for a free account now. It takes only 30 seconds!

USB Midi Device from old Gamepad

USB Midi Device from old Gamepad

This project can easily be done if you get cheap buttons and a second-hand controller.You can buy HID USB boards and build your own totally from scratch. To make the process even easier, salvage an old USB gamepad and all you need is just a few parts.
What you need:
1 USB Gamepad (I used an old Gravis Gamepad Pro.):
1 small project box:
10 push-button n.o. switches (Normally Open: Contact closes when button pressed.):
10 LEDs & 220-Ohm resistors (optional):
Equipment::
small screwdrivers:
soldering iron:
solder:
drill (I needed 1/4in and 5mm bits):
wire cutters/strippers:
ruler and square:
electrical tape:
solder, solder braid (clean up messes):
rubber feet (so it doesn’t move as you’re jamming):
small spool of shielded wire

Visit Here for more.

 

More Articles to Read

Vertical Pole Climbing Robot
Vertical Pole Climbing Robot
ESP8266 Weather Station Projects
ESP8266 Weather Station Projects
Single tube Lethal Nixie clock
Single tube Lethal Nixie clock
How to make a simple 1 watt audio amplifier (LM386 based)
How to make a simple 1 watt audio amplifier (LM386 based)
Flashing Binaries to DRA7xx Factory Boards Using Device Firmware Upgrade
Flashing Binaries to DRA7xx Factory Boards Using Device Firmware Upgrade
Dot² isn’t your typical coffee table
Dot² isn’t your typical coffee table
Debugging ARM Cortex-M0+ HardFaults
Debugging ARM Cortex-M0+ HardFaults
EMP Jammer build
EMP Jammer build
A 3D-printed e-drum pad
A 3D-printed e-drum pad
Interactive geodesic LED dome = extreme geometric fun!
Interactive geodesic LED dome = extreme geometric fun!

Top




Shares