Organize and Share your Electronics the way you want. Sign-Up for a free account now. It takes only 30 seconds!

DayLight Alarm

DayLight Alarm

The circuit presented here wakes you up with a loud alarm at the break of the daylight. Once again the 555 timer is used here. It is working as an astable multivibrator at a frequency of about 1kHz.
The circuit’s operation can be explained as follows:

When no light falls on the LDR, the transistor is pulled high by the variable resistor. Hence the transistor is OFF and the reset pin of the 555 is pulled low. Due the this the 555 is reset.

When light falls on the LDR, its resistance decreases and pulls the base of the transistor low hence turning it ON. This pulls the reset pin 4 of the 555 high and hence enables the 555 oscillator and a sound is produced by the speaker.

The variable 100K resistor has to be adjusted to set the light intensity that triggers the alarm.

Visit Here for more.

 

More Articles to Read

Emulate a Commodore 64 keyboard with a modern PC and an Arduino
Emulate a Commodore 64 keyboard with a modern PC and an Arduino
USB2005 and USB97C202 Sharing ATA/ATAPI Drive w/ Another Controller
USB2005 and USB97C202 Sharing ATA/ATAPI Drive w/ Another Controller
Robotic Cat Laser
Robotic Cat Laser
LED traffic light
LED traffic light
Estimating Power for ADSP-BF561 Blackfin® Processors
Estimating Power for ADSP-BF561 Blackfin® Processors
Teach Your Arduino to Switch Itself Off!
Teach Your Arduino to Switch Itself Off!
Control a tracked robot with your mind (or joystick)
Control a tracked robot with your mind (or joystick)
A 400W (1kW Peak) 100A electronic load using linear MOSFETs
A 400W (1kW Peak) 100A electronic load using linear MOSFETs
Shirt Pocket Transceiver with the Si5351 and OLED
Shirt Pocket Transceiver with the Si5351 and OLED
All metal C930e webcam
All metal C930e webcam

Top




Shares