Organize and Share your Electronics the way you want. Sign-Up for a free account now. It takes only 30 seconds!

Temperature Indicator

Temperature Indicator

This circuit uses a Dallas DS1621 temperature sensor which indicates the temparature of the device. The temperature sensor has an termal alarm output, which becomes high when the temperature of the device exceeds a user defined value.
When the temperature drops below a user defined value, the alarm output becomes low. In this way any amonut of hysteresis can be programmed. The values are stored in a special register of the device that is nonvolatile. The signal of the alarm output is amplified by a BC557 PNP transistor, that drives a relay that can switch a heater element or a blower on or off. The temperature settings and readings are communicated to/from the device over a simple 2-wire serial interface. An ATMEL 90S2313 microcontroller controls the serial communication to/from the DS1621.The microcontroller also controls three LED, only one of the LED’s is on when the temparature is within a certain range. The range of the temperature in which the LED’s are on can be set by the user in the program code. The circuit needs to be powered by a 5V power supply, which can be obtained from a wall-wart.

It contains only a few parts, a DS1621 temperature sensor, a attiny2313 micrcontroller,three LED’s one relay and some resitors. I have made a little printed circuit board for it.

It contains only a few parts, a DS1621 temperature sensor, a attiny2313 micrcontroller,three LED’s one relay and some resitors. I have made a little printed circuit board for it.

The software for this projects is made with the AVR Bascom compiler.

Visit Here for more.

 

More Articles to Read

Vertical Pole Climbing Robot
Vertical Pole Climbing Robot
ESP8266 Weather Station Projects
ESP8266 Weather Station Projects
Single tube Lethal Nixie clock
Single tube Lethal Nixie clock
How to make a simple 1 watt audio amplifier (LM386 based)
How to make a simple 1 watt audio amplifier (LM386 based)
Flashing Binaries to DRA7xx Factory Boards Using Device Firmware Upgrade
Flashing Binaries to DRA7xx Factory Boards Using Device Firmware Upgrade
Dot² isn’t your typical coffee table
Dot² isn’t your typical coffee table
Debugging ARM Cortex-M0+ HardFaults
Debugging ARM Cortex-M0+ HardFaults
EMP Jammer build
EMP Jammer build
A 3D-printed e-drum pad
A 3D-printed e-drum pad
Interactive geodesic LED dome = extreme geometric fun!
Interactive geodesic LED dome = extreme geometric fun!

Top




Shares