Browse over 10,000 Electronics Projects using the Page Numbering provided at the bottom of each Page.

Making PCB vias with conductive ink

Making PCB vias with conductive ink

Here’s an alternative method for making PCB vias using conductive ink from Diyouware:

20151121_121823

We developed an alternative method for making PCB vias through-hole using our robot.
As you probably know the traditional DIY method consists in threading a wire through the holes and then soldering it and then cutting it off. For example, if we have 100 vias in our PCB, we have to insert the thin wire on each hole, cut it and solder it 200 times. This is time-consuming, but also tedious, absurd, prone to failures and produces a melancholic state of mind.:-)
So we decide to innovate in this area developing a new method which consists in drilling blind vias instead of holes and filling them with conductive ink.

More details at Diyouware blog.

 

 




Top