Organize and Share your Electronics the way you want. Sign-Up for a free account now. It takes only 30 seconds!

A CNC pickup winding machine built on an ATmega8

A CNC pickup winding machine built on an ATmega8

Davide Gironi blogged about his DIY ATmega based CNC pickup winding machine:

A pickup winding machine it is used to wind a guitar pickup.
You can find my previous ATmega manual pickup winding machine here
This project is a manual / CNC pickup winding machine, built on top of an ATmega8 microcontroller.

More details at Davide Gironi’s blog.

Check out the video after the break.

Read more Here

 

More Articles to Read

Guide to build your 3.3v power supply
Guide to build your 3.3v power supply
SDR radio breathes life into a 75 year old Marconi CR100
SDR radio breathes life into a 75 year old Marconi CR100
A Time for Ranting!
A Time for Ranting!
Emulate a Commodore 64 keyboard with a modern PC and an Arduino
Emulate a Commodore 64 keyboard with a modern PC and an Arduino
USB2005 and USB97C202 Sharing ATA/ATAPI Drive w/ Another Controller
USB2005 and USB97C202 Sharing ATA/ATAPI Drive w/ Another Controller
Robotic Cat Laser
Robotic Cat Laser
LED traffic light
LED traffic light
Estimating Power for ADSP-BF561 Blackfin® Processors
Estimating Power for ADSP-BF561 Blackfin® Processors
Teach Your Arduino to Switch Itself Off!
Teach Your Arduino to Switch Itself Off!
Control a tracked robot with your mind (or joystick)
Control a tracked robot with your mind (or joystick)

Top




Shares