Organize and Share your Electronics the way you want. Sign-Up for a free account now. It takes only 30 seconds!

App note: Selecting inductors for buck converters

App note: Selecting inductors for buck converters

An application note (PDF!) from Texas Instruments on inductor selection:

This application report provides design information to help select an off-the-shelf inductor for any continuous-mode buck converter application.
The first part shows how the designer should estimate his requirements, specifically the required inductance.
The next part takes an off-the-shelf inductor and shows how to interpret the specs provided by the vendor in greater detail. A step-by-step procedure is provided.
Finally, all the previous steps are consolidated in a single design table, which answers the question: “How will the selected inductor actually perform in a specific application?”

Read more Here

 

More Articles to Read

Vertical Pole Climbing Robot
Vertical Pole Climbing Robot
ESP8266 Weather Station Projects
ESP8266 Weather Station Projects
Single tube Lethal Nixie clock
Single tube Lethal Nixie clock
How to make a simple 1 watt audio amplifier (LM386 based)
How to make a simple 1 watt audio amplifier (LM386 based)
Flashing Binaries to DRA7xx Factory Boards Using Device Firmware Upgrade
Flashing Binaries to DRA7xx Factory Boards Using Device Firmware Upgrade
Dot² isn’t your typical coffee table
Dot² isn’t your typical coffee table
Debugging ARM Cortex-M0+ HardFaults
Debugging ARM Cortex-M0+ HardFaults
EMP Jammer build
EMP Jammer build
A 3D-printed e-drum pad
A 3D-printed e-drum pad
Interactive geodesic LED dome = extreme geometric fun!
Interactive geodesic LED dome = extreme geometric fun!

Top




Shares