Organize and Share your Electronics the way you want. Sign-Up for a free account now. It takes only 30 seconds!

MPPT solar charger

MPPT solar charger

Lukas Fässler has designed and built an MPPT solar charger:

One of my main goals with this design is to archieve very low standby current, somewhere in the tens of microamps. The basis for this is a low-power buck on the basis of a Texas TPS62120 where the microcontroller can switch the output voltage between 2.2 and 3.3 volts nominally. This works as intended. With no load and the output voltage low, the supply consumes 12.9 microamps at 12V input voltage. With the high output voltage the idle current goes up to 14.3uA. Quite a bit of that current is due to the voltage divider that sets the output voltage. The regulator itself consumes about 9uA in both cases.

 

Read more Here

 

More Articles to Read

Estimating Power for ADSP-BF561 Blackfin® Processors
Estimating Power for ADSP-BF561 Blackfin® Processors
Teach Your Arduino to Switch Itself Off!
Teach Your Arduino to Switch Itself Off!
Control a tracked robot with your mind (or joystick)
Control a tracked robot with your mind (or joystick)
A 400W (1kW Peak) 100A electronic load using linear MOSFETs
A 400W (1kW Peak) 100A electronic load using linear MOSFETs
Shirt Pocket Transceiver with the Si5351 and OLED
Shirt Pocket Transceiver with the Si5351 and OLED
All metal C930e webcam
All metal C930e webcam
The Soldering Tools That Make Your Life Easier
The Soldering Tools That Make Your Life Easier
App note: Operation evaluation of ultra low ON resistance MOSFET supporting quick charge for 1 c ...
App note: Operation evaluation of ultra low ON resistance MOSFET supporting quick charge for 1 cell Lithium ion battery protection
Synthesized Sidetone
Synthesized Sidetone
App note: Application precautions: Power MOSFET application notes
App note: Application precautions: Power MOSFET application notes

Top




Shares