Browse over 10,000 Electronics Projects using the Page Numbering provided at the bottom of each Page.

EasyESP-1: a rapid prototyping and development board for ESP8266

EasyESP-1: a rapid prototyping and development board for ESP8266

Raj over at Embedded Lab has designed a development board for ESP8266:

EasyESP-1 is a rapid prototyping board for the low-cost, WiFi-enabled ESP8266 microcontroller. With an onboard USB-to-Serial converter pre-installed, EasyESP-1 does not require any additional hardware to download your application firmware to the ESP8266 chip. The ESP module used in this development board is ESP-12E. All the I/O pins are broken out to 0.1” female headers for easy access, as well as to standard Grove connectors for connecting Grove sensors and other compatible modules. The 180-point breadboard further facilitates experimenting and testing of external circuits.

List of features

  • Easy access to all GPIO pin through female headers and Grove connectors
  • On-board USB-UART chip for easy programming and debugging
  • 180-point breadboard for experimenting with test circuits
  • On-board 3.3V (800 mA) regulated power supply
  • Two tact switches for user inputs, and one output LED
  • Slide switch to enable/disable auto Wake Up feature during Sleep mode

Full details at Embedded Lab blog. It’s also up on Tindie.

 

More Articles to Read

avatar
EEWeb
avatar
Dangerous Prototypes
avatar
EEWeb
avatar
Arduino Blog
avatar
Arduino Blog
avatar
Ken Shirrif
avatar
Dangerous Prototypes
avatar
EEWeb
avatar
Arduino Blog
avatar
Freetronics
avatar
Arduino Blog
avatar
Dangerous Prototypes

Top




Shares