Organize and Share your Electronics the way you want. Sign-Up for a free account now. It takes only 30 seconds!

MS Mic Version 2

MS Mic Version 2

This mic uses two Panasonic WM-55A103 cardioid electret capsules whose outputs are combined to form a figure eight mic for the side output.
With the mic head mounted directly on the case, the mic is very sensitive to handling noise and floor-transmitted noise. I used a length of five-conductor-plus-shield-and-drain cable and DIN connectors to make an extension cord so I could use the mic with a conventional mic stand. The capsules are a bit sensitive to hum pickup, so I made an enclosure out of brass mesh. The mesh assembly should not be soldered directly to the DIN connector because this results in a VERY resonant structure, almost like a tuning fork. I wrapped the top of the DIN connector with weather stripping and fitted the mesh enclosure over that. The mesh is grounded to the DIN connector with a piece of wire and a wrapping of electrical tape completes the assembly.

Visit Here for more.







 

More Articles to Read

Smart "Homer"
Smart "Homer"
A DIY Segway-style vehicle
A DIY Segway-style vehicle
Superbeta transistors inside: Die photos and analysis of the LM108 op amp
Superbeta transistors inside: Die photos and analysis of the LM108 op amp
Peeqo is a desktop bot that communicates through GIFs
Peeqo is a desktop bot that communicates through GIFs
Using a Programmable Input Multiplier to Minimize Integer Boundary Spurs
Using a Programmable Input Multiplier to Minimize Integer Boundary Spurs
Serial seven segment LED display shield
Serial seven segment LED display shield
G-code controlled drawing plotter
G-code controlled drawing plotter
An Arduino round word clock
An Arduino round word clock
The Sandwich-o-Matic will make your lunch automatically
The Sandwich-o-Matic will make your lunch automatically
Scalar Network Analyser Jr
Scalar Network Analyser Jr

Top


Shares