This is second version of my simple LM399 based reference board, when i made my last version i received quite few small feedback form eevblog forum member, so i have made few improvements in second reversion accumulating those suggestions.
Fist improvements is , Reverse probity protection, Now you can see in left corner a P-channel Mosfet and a resistor forming reverse polarity protection. Now it can save its self from damage caused by reverse polarity.
With reverse polarity protection comes this little red power led indicating supply to the board.
one major change is , now there is this 1k 10 Turn pot with 10PPM Opamp gain setting registers with help of this pot now it is possible to adjust output voltage from reference to exactly 10.00000V. And it can be easily jumpered if not needed.
There are few minor change in the PCB as well slots cut around actual reference chip is now wider, so now it is little bit easier to fit insulation foam cap, there are few minor changes on silk screen indicates input voltage, input and output voltage polarity.
Source is available in my Github Repo.
|Plot over 17 Hours 30 Minute , Temperature Ranging from 14 to 27 Degree C|