Organize and Share your Electronics the way you want. Sign-Up for a free account now. It takes only 30 seconds!

How to install an Inverter into a vehicle

How to install an Inverter into a vehicle

Have you ever wanted to just plug an AC appliance into your car but it didnt have any jacks? Well here is an article on how to add 110v AC Power jacks to your car!
Tools and parts required:

750 Watt Power Inverter.
Drill and a few bits ranging in sizes
Ribbed wire sheathing
Wire strippers
Wire
Screw drivers
Liquid electrical tape or heat shrink
Soldering iron with fine tip
Faucet washers or rubber gaskets
Some basic knowledge and common sense
Dremel kit

First get the inverter ready by removing the control panel if you want the controls in your dash and keep track of where the wires go.

You can remove any led lights with the soldering iron, be very careful not to damage or overheat the leds. Its best to heat the solder points from the backside of the pcb ( printed circuit board) and pull them out. Than you will extend the lights with wires, I used phone wire for the stiffness so it was easy to poke the wire back thru the pcb and resolder it.

Heat the points here circled, be careful not to run the solder together from each side. You want to avoid making a solder bridge.

Visit Here for more.







 

More Articles to Read

Freetronics Christmas Gift Guide
Freetronics Christmas Gift Guide
The Sandwich-o-Matic will make your lunch automatically
The Sandwich-o-Matic will make your lunch automatically
Scalar Network Analyser Jr
Scalar Network Analyser Jr
An Arduino-controlled automated whiskey distillery
An Arduino-controlled automated whiskey distillery
The Rex800 looks like a dinosaur Terminator
The Rex800 looks like a dinosaur Terminator
Home Environment Monitor
Home Environment Monitor
Understanding the Operation of the Frequency Synthesizer in Maxim’s RF Transceivers
Understanding the Operation of the Frequency Synthesizer in Maxim’s RF Transceivers
App note: EPIC: Electro-Pyrotechnic Initiator Chip Resistor
App note: EPIC: Electro-Pyrotechnic Initiator Chip Resistor
Noisy ESP8266
Noisy ESP8266
Noisy ESP8266
Noisy ESP8266
App note: Noise analysis for high-speed op amps
App note: Noise analysis for high-speed op amps
Skill Sunday: Arrays
Skill Sunday: Arrays
App note: Infrared remote control implementation with MSP430FR4xx
App note: Infrared remote control implementation with MSP430FR4xx
Gesture Controlled Smart Home
Gesture Controlled Smart Home
Design for a Wideband, Differential Transimpedance DAC Output
Design for a Wideband, Differential Transimpedance DAC Output
Wrist thrusters let you fly through the water effortlessly
Wrist thrusters let you fly through the water effortlessly
Bertan/Spellman 225-20R HV power supply teardown
Bertan/Spellman 225-20R HV power supply teardown
Blinking Christmas Lights
Blinking Christmas Lights
Adjusting clock with alarm, hygrometer & thermometer on 1.8″ ST7735 display
Adjusting clock with alarm, hygrometer & thermometer on 1.8″ ST7735 display
Adding an “extra sense” with rangefinders
Adding an “extra sense” with rangefinders

Top


Shares