Browse over 10,000 Electronics Projects using the Page Numbering provided at the bottom of each Page.

Flasher with 2 Led

Flasher with 2 Led

The circuit is based on the IC1 that is 555, for the creation of alternate flashes from the two led D1-2, that can be also different colour. The frequency of alternation can be regulated from the trimmer R3 and from the C1, if changes his capacity.
The supply can become from a battery or from one separate power supply. A use of circuit is creation ” clue ” of alarm. Exists the possibility is connected at the same time with D1-2, the optocoupler IC2-3, with that we externally drive circuits, for various uses.

Part List
R1-2= 1.5Kohm C2= 100nF 63V D1-2= LED 3mm
R3= 250Kohm trimmer C3= 100uF 16V BATT= 9V Battery
R4-5= 470 ohm IC1= 555 S1= Push Button or switch on-off
C1= 10uF 16V IC2-3= 4N25 optocoupler

Visit Here for more.

 

More Articles to Read

Single-Sided USB Charger
Single-Sided USB Charger
A FPGA controlled RGB LED MATRIX for Incredible Effects – the Hardware
A FPGA controlled RGB LED MATRIX for Incredible Effects – the Hardware
Using Nanotimers to Reduce IoT System Power Consumption by an Order of Magnitude
Using Nanotimers to Reduce IoT System Power Consumption by an Order of Magnitude
Replace a microwave’s beeping with the Windows XP startup sound
Replace a microwave’s beeping with the Windows XP startup sound
A DIY Laser Scanning Microscope
A DIY Laser Scanning Microscope
Reverse-engineering the surprisingly advanced ALU of the 8008 microprocessor
Reverse-engineering the surprisingly advanced ALU of the 8008 microprocessor
ESP8266 LED lighting: QuinLED v2.6 PCB
ESP8266 LED lighting: QuinLED v2.6 PCB
Switching LVDS Graphics in a Laptop Computer
Switching LVDS Graphics in a Laptop Computer
Teleknitting: TV-based string art
Teleknitting: TV-based string art
DIY Bubble Machine
DIY Bubble Machine
Start your day with Nerf target practice!
Start your day with Nerf target practice!
Teardown of a Peaktech 6225A
Teardown of a Peaktech 6225A

Top




Shares