Browse over 10,000 Electronics Projects using the Page Numbering provided at the bottom of each Page.

AVR ISP Programmer (In-Sytem programmer) for ATMEL

AVR ISP Programmer (In-Sytem programmer) for ATMEL

The schematic for AVR ISP show in picture 1, IC1 DS275 use for RS 232 Driver becuase it small and no need external component IC2 AT90S2313 is the CPU to communication and receive command from PC that run AVR Prog to control target CPU.
This firmware compiled to run on crystal 4MHz ,so the target device must connect crystal 4MHz on XTAL1 and XTAL2 pin.But, if your target device use internal oscillator and enabled .its not need any external oscillator

To use this AVR ISP with target device that run at 8MHz you can do this by recompile the firmware source code.

Visit Here for more.

 

More Articles to Read

avatar
EEWeb
avatar
Dangerous Prototypes
avatar
EEWeb
avatar
Arduino Blog
avatar
Arduino Blog
avatar
Ken Shirrif
avatar
Dangerous Prototypes
avatar
EEWeb
avatar
Arduino Blog
avatar
Freetronics
avatar
Arduino Blog
avatar
Dangerous Prototypes

Top




Shares