Browse over 10,000 Electronics Projects

Project mangOH, open source reference design for the CF3 form factor modules

Project mangOH, open source reference design for the CF3 form factor modules

Project mangOH™ is an open source reference design for the CF3 form factor modules, including Sierra Wireless WP Series & HL Series. When used with WP Series, it provides an out-of-the box wireless and cloud connected reference design, and enables rapid prototyping of new ideas for IoT developers. With its Arduino connector and its 3 IoT connectors fully supported by the Legato™ platform, you can try out multiple wireless and sensor technology combinations to best meet your specific use-case requirements. Once your prototype is complete, you can then reuse the industrial-grade design and IoT modules in final production.

Hardware specs include:

  • Size: 100mm x 120mm (4in x 4.75in)
  • 3 IoT Connectors
  • 2 CF3 connectors
  • 1 Arduino Leonardo connector
  • 1 USB 2.0 OTG
  • 1 USB 2.0 Host
  • 1 RS232/Serial
  • 1 RJ45/Ethernet
  • Audio Jack
  • SD card
  • 3 SMA/uFL antenna connectors (Primary, Secondary/Diversity, GPS)
  • Accelerometer, Gyroscope
  • Battery/Battery Charging Management

 

LICENSE



Advertisement1


Creative Commons License
Project mangOH by Sierra Wireless is licensed under a Creative Commons Attribution 4.0 International License.
Based on a work at source.sierrawireless.com/mangOH

3D PRINTING

Project mangOH design is meant to fit in a Euro card standard size casing (100x120mm). Face plates can be 3D printed easily depending on the IoT Connectors you are using:

All 3D printable files can be found on: http://www.thingiverse.com/Sierra_Wireless_MangOH/designs

More info on the official homepage Project mangOH

 


Top