Browse over 10,000 Electronics Projects

Voltage doubler circuit using IC555

Voltage doubler circuit using IC555

Devices such as transformers are usually used where a certain voltage level is required but unfortunately transformers are not feasible everywhere because of its robust size and price. To deal with instants we use special yet simple circuit called voltage doublers which is capable of doubling the input voltage fed to it Ex. If we fed Vin as 6 v we will get 12 v as Vout.


The main principle behind the working of this circuit is the capability of charging and discharging of a capacitor. In this Circuit timer IC 555 serves as an oscillator for the entire circuit. The IC 555 was wired as an astable multivibrator which generates square signal of frequency 2KHz. The frequency of the astable multivibrator depends on the components R1,R2 and C2.


So the Pin3 of the IC 555 emits square wave of 2Khz.  When logic level of the output signal is high or 1 the diode D2 and capacitor C3 is in forward biased condition. This makes the capacitor C3 to get charged and the diode D1 is used to protect the C3 from getting discharged when the logic goes low. This action in turn makes the capacitor C4 to gets charged with a combined voltage from C3 and power supply.

This makes the output voltage to be doubled from that of the input voltage source. This operation was done by these components C3,C4 and D1,D2. Therefore at the point of output (between D2 and C4 ) we will obtain an output voltage of about 12V.


  • Make sure your input voltage stays between 3v to 12v or it may destroy the timer IC 555.

The post Voltage doubler circuit using IC555 appeared first on Gadgetronicx.