Organize and Share your Electronics the way you want. Sign-Up for a free account now. It takes only 30 seconds!

MMC to PIC16F876 circuit diagram

MMC to PIC16F876 circuit diagram

The MMC prototype using a PIC16F876 running on 3.3v. The MMC is in a socket which is soldered to a small pcb.

Parts used:

16F876 28 pin mcu
Max233A for serial
An 24C65 I2C eeprom
LM2937 3.3 reg.
10 Mhz xtal
Molex MMC socket
DB9 connector
Melabs? Proto3 board
Misc: 4 caps, 6 res, pwr LED,reset switch and headers?
?
The small pcb has a 7 pin male header at the bottom which plugs into a female header on the prototype. This allows one to use the? alternative connection shown below if an MMC socket is not available. The DB9 serial connector serves a dual purpose. It is used for data I/O to and also to program the 16F876 serially. A MAX233A was used instead of a MAX232 simply because it requires no external capacitors. In order for the 16F876 to operate at 3.3v its built-in brownout protection feature (BOR) has to be disabled. The I2C eeprom is used as a temporary storage area. The MMC writes data in blocks of 512 bytes, therefore it is not possible to write just one or two bytes at a time (does not apply to reading). Therefore one needs to store the data somewhere until it reaches a minimum of 512 bytes. Any I2C eeprom can be used as long as it can hold 512 bytes or more of data.

Visit Here for more.

 

More Articles to Read

App note: Testing inductors at application frequencies
App note: Testing inductors at application frequencies
1968 Princeton Reverb Repairs
1968 Princeton Reverb Repairs
Skill Sunday: Power Over Ethernet for Arduino
Skill Sunday: Power Over Ethernet for Arduino
More on Color TFT Displays ~ The Big Ones — 240 X 320
More on Color TFT Displays ~ The Big Ones — 240 X 320
Magnetic Rotary Encoder
Magnetic Rotary Encoder
Vertical Pole Climbing Robot
Vertical Pole Climbing Robot
ESP8266 Weather Station Projects
ESP8266 Weather Station Projects
Single tube Lethal Nixie clock
Single tube Lethal Nixie clock
How to make a simple 1 watt audio amplifier (LM386 based)
How to make a simple 1 watt audio amplifier (LM386 based)
Flashing Binaries to DRA7xx Factory Boards Using Device Firmware Upgrade
Flashing Binaries to DRA7xx Factory Boards Using Device Firmware Upgrade

Top




Shares