Organize and Share your Electronics the way you want. Sign-Up for a free account now. It takes only 30 seconds!

10 relay board for LPT-16-0

10 relay board for LPT-16-0

There are 10 relays DPCO(dual pole change over), which are activated using a 12V supply, and around 60mA current.
Note that the diode D1 is there to protect the rest of the circuitry (the buffer) from the current which flows once the relay is switched off. The current is produced because the relay coil builds a back emf to counter act the magentic field built across it. When the buffer is switched off, the magnetic field will still exist and will need to discharge via the coil . The diode enables the current to flow in a loop without damaging the circuitry.

Visit Here for more.

 

More Articles to Read

Debugging ARM Cortex-M0+ HardFaults
Debugging ARM Cortex-M0+ HardFaults
EMP Jammer build
EMP Jammer build
A 3D-printed e-drum pad
A 3D-printed e-drum pad
Interactive geodesic LED dome = extreme geometric fun!
Interactive geodesic LED dome = extreme geometric fun!
Guide to build your 3.3v power supply
Guide to build your 3.3v power supply
SDR radio breathes life into a 75 year old Marconi CR100
SDR radio breathes life into a 75 year old Marconi CR100
A Time for Ranting!
A Time for Ranting!
Emulate a Commodore 64 keyboard with a modern PC and an Arduino
Emulate a Commodore 64 keyboard with a modern PC and an Arduino
USB2005 and USB97C202 Sharing ATA/ATAPI Drive w/ Another Controller
USB2005 and USB97C202 Sharing ATA/ATAPI Drive w/ Another Controller
Robotic Cat Laser
Robotic Cat Laser

Top




Shares