Organize and Share your Electronics the way you want. Sign-Up for a free account now. It takes only 30 seconds!

MiniPOV v2

MiniPOV v2

This project is a second revision of the MiniPOV. This version changes from the PIC 16F630 chip to the Atmel ATtiny2313, which is a little more expensive but has many improved features.
The microcontroller used for the MiniPOV2 is an Atmel 20-pin RISC device called the ATtiny2313. This chip was chosen because it is the cheapest one that has an internal oscillator (no external crystal/clock necessary) and enough I/O pins to give every LED a pin.

The MiniPOV2 kit comes with a 2xAA battery case. The resistor values were chosen with the expectation that you’ll use alkalines, but rechargables should be OK too. In fact, any high-capacity 2.5 to 5VDC supply can be used (but certainly not a 9V!). Of course, if the voltage goes up, the choke resistors for the LED have to be larger to keep the same brightness.

Visit Here for more.







 

More Articles to Read

CTCSS fingerprinting: A method for transmitter identification
CTCSS fingerprinting: A method for transmitter identification
TI DLP® Pico™ Technology for Aftermarket Head-up Displays
TI DLP® Pico™ Technology for Aftermarket Head-up Displays
Brute force computation for cheap log digital potentiometer
Brute force computation for cheap log digital potentiometer
Smart "Homer"
Smart "Homer"
A DIY Segway-style vehicle
A DIY Segway-style vehicle
Superbeta transistors inside: Die photos and analysis of the LM108 op amp
Superbeta transistors inside: Die photos and analysis of the LM108 op amp
Peeqo is a desktop bot that communicates through GIFs
Peeqo is a desktop bot that communicates through GIFs
Using a Programmable Input Multiplier to Minimize Integer Boundary Spurs
Using a Programmable Input Multiplier to Minimize Integer Boundary Spurs
Serial seven segment LED display shield
Serial seven segment LED display shield
G-code controlled drawing plotter
G-code controlled drawing plotter

Top


Shares