Organize and Share your Electronics the way you want. Sign-Up for a free account now. It takes only 30 seconds!

A homebrew Simpleceiver project

A homebrew Simpleceiver project

Pete Juliano, N6QW, has been working on a DIY Simple-ceiver project. He writes:

Today I finished what I call the main board which is comprised of the Mixer stage (SBL-1) followed by the 1st IF Amplifier which is a 12 MHz design consisting of two J310 JFETS configured as a Dual Gate MOSFET. The board also contains the new 4 pole Crystal Filter followed by the 2nd IF AMP stage which is similar to the 1st IF Amp. Below is a photo of that board. I have tried to label the various sub-circuits so you can see the layout. The “squares” are 2/10 inch. The W1REX MePads would work ideal for this board.

Project info at Pete N6QW blog.

Check out the video after the break.

Read more Here

 

More Articles to Read

Emulate a Commodore 64 keyboard with a modern PC and an Arduino
Emulate a Commodore 64 keyboard with a modern PC and an Arduino
USB2005 and USB97C202 Sharing ATA/ATAPI Drive w/ Another Controller
USB2005 and USB97C202 Sharing ATA/ATAPI Drive w/ Another Controller
Robotic Cat Laser
Robotic Cat Laser
LED traffic light
LED traffic light
Estimating Power for ADSP-BF561 Blackfin® Processors
Estimating Power for ADSP-BF561 Blackfin® Processors
Teach Your Arduino to Switch Itself Off!
Teach Your Arduino to Switch Itself Off!
Control a tracked robot with your mind (or joystick)
Control a tracked robot with your mind (or joystick)
A 400W (1kW Peak) 100A electronic load using linear MOSFETs
A 400W (1kW Peak) 100A electronic load using linear MOSFETs
Shirt Pocket Transceiver with the Si5351 and OLED
Shirt Pocket Transceiver with the Si5351 and OLED
All metal C930e webcam
All metal C930e webcam

Top




Shares