Organize and Share your Electronics the way you want. Sign-Up for a free account now. It takes only 30 seconds!

Christmas DIY project for children 2/3: Traffic Light Soldering Kit

Christmas DIY project for children 2/3: Traffic Light Soldering Kit

Stop and Go Kit v1

This is a soldering kit that you build yourself! The holes on the base of the stop-and-go light are LEGO compatible so you can build this kit into your various brick projects. You are welcome to create a derivative of this kit as long as it abides by the open source hardware definition.

This kit cycles through a red, yellow, and green LED from an ATtiny85. The code is written in Arduino.

This kit assumes you know how to solder. If not, there are plenty of online tutorials on how to solder. The kit is fairly quick to put together, roughly 10 minutes, and the chip has been programmed for you!

Materials and tools:

Here are the parts you’ll need to get stared:

3 LEDs (with a max current of 20mA)

1 220-ohm Resistor

2 47-ohm Resistors

1 ATtiny85

1 battery holder

1 3v battery

1 switch

Here are the tools you’ll need to get stared:

Soldering Iron

Solder

Wire Clippers

Here you can find more info and a video showing what to do!

 

More Articles to Read

Vertical Pole Climbing Robot
Vertical Pole Climbing Robot
ESP8266 Weather Station Projects
ESP8266 Weather Station Projects
Single tube Lethal Nixie clock
Single tube Lethal Nixie clock
How to make a simple 1 watt audio amplifier (LM386 based)
How to make a simple 1 watt audio amplifier (LM386 based)
Flashing Binaries to DRA7xx Factory Boards Using Device Firmware Upgrade
Flashing Binaries to DRA7xx Factory Boards Using Device Firmware Upgrade
Dot² isn’t your typical coffee table
Dot² isn’t your typical coffee table
Debugging ARM Cortex-M0+ HardFaults
Debugging ARM Cortex-M0+ HardFaults
EMP Jammer build
EMP Jammer build
A 3D-printed e-drum pad
A 3D-printed e-drum pad
Interactive geodesic LED dome = extreme geometric fun!
Interactive geodesic LED dome = extreme geometric fun!

Top




Shares