Organize and Share your Electronics the way you want. Sign-Up for a free account now. It takes only 30 seconds!

Infrared remote control receiver for Media Centers

Infrared remote control receiver for Media Centers

The only thing that was missing was a remote control to switch On or Off my Media Center. After I searched on the net to buy a complete remote control system, I saw that the price was a little bit high (about 90 euros). I checked my stuff to find my old 7-in-one remote control that I had bought 2 years ago and I started to build my own remote control receiver circuit.
The circuit consists of ordinary components (except of ATtiny13 in some cases). The IC1 is an infrared receiver at 30 kHz. The T2 makes the switch On/Off of Media Center when it gets a High level by IC2. The K2 is connected at the “power switch” connector of your PC’s mainboard (motherboard). The two diodes are put to make the connection of K2 to the mainboard, easy. You don’t have to worry about which polarity you have to connect this connector to the mainboard. Connect it as you wish. K1 is connected to the power switch (button) of your PC’s case. So, you can turn On/Off your media Center with both remote control and your case’s power on/off switch. K3 is connected at your RS-232 port of your Media Center. It can work on both real RS-232 ports and USB-to-RS232 converters, in case you haven’t got a real RS-232 port.

The +5V can be taken by 20pin ATX connector and specific by the pin “+5VSB” (purple cable). The power supply of the circuit must be done by this cable (+5VSB) because it’s the only cable that has +5V voltage when the computer is in hibernate, stand-by or power-off mode. The circuit has to be power supplied always for being functional. The ground pin (GND) of the circuit has to be connected with one of the black cables.

At the circuit’s photo you cannot see the R4, D3 and C2, because they are included in RS-232 connector’s case to reduse the number of the used cables.

Visit Here for more.

 

More Articles to Read

Debugging ARM Cortex-M0+ HardFaults
Debugging ARM Cortex-M0+ HardFaults
EMP Jammer build
EMP Jammer build
A 3D-printed e-drum pad
A 3D-printed e-drum pad
Interactive geodesic LED dome = extreme geometric fun!
Interactive geodesic LED dome = extreme geometric fun!
Guide to build your 3.3v power supply
Guide to build your 3.3v power supply
SDR radio breathes life into a 75 year old Marconi CR100
SDR radio breathes life into a 75 year old Marconi CR100
A Time for Ranting!
A Time for Ranting!
Emulate a Commodore 64 keyboard with a modern PC and an Arduino
Emulate a Commodore 64 keyboard with a modern PC and an Arduino
USB2005 and USB97C202 Sharing ATA/ATAPI Drive w/ Another Controller
USB2005 and USB97C202 Sharing ATA/ATAPI Drive w/ Another Controller
Robotic Cat Laser
Robotic Cat Laser

Top




Shares