Will It Work? · Guide
MoCA adapters: Ethernet over your TV coax cable
By Bulan Sarkar, founder of ElectronicsInfoline (since 2000)
If your home has coax TV outlets in the rooms that need a cable, MoCA adapters can carry Ethernet over that coax. The figures here come from the MoCA Alliance and from two adapter makers' own spec pages and datasheets.
What a MoCA adapter does
One adapter goes by the router with an Ethernet cable to a LAN port and a coax lead to the wall outlet. A second goes in the other room, coax to its outlet and Ethernet to the TV, console or computer. You need at least two adapters, unless your modem, router or gateway has MoCA built in (ScreenBeam). A network can have up to 16 devices (ScreenBeam)(goCoax).
The internet does not need to come in by cable. With fibre or another service, MoCA just links rooms over the coax you already have (goCoax).
Speed: the Ethernet port sets the ceiling
MoCA 2.5 reaches real-world home networking speeds of up to 2.5 Gbps, according to the MoCA Alliance (MoCA Alliance). One maker's adapter lists up to 2.5 Gbps over the coax and a 10/100/2500 Ethernet port (ScreenBeam); another lists 2.5 Gbps real traffic throughput and a 2.5GbE port (goCoax). A third model from the same maker also lists up to 2.5 Gbps over the coax, but its port is 10/100/1000, and the maker gives wired speeds up to 1 Gbps (ScreenBeam).
A pair with one of each runs at 1 Gbps, the slower end. The device's own port counts too: a computer with a gigabit port gets no more than 1 Gbps from a 2.5GbE adapter. The maker's datasheet adds that throughput varies with the condition and noise on your coax and with the Ethernet adapter in each computer (ScreenBeam). To check which speed your router's ports and your cable carry, see the Ethernet port and cable checker.
Cable internet and MoCA on the same coax
MoCA adapters use 1125 to 1675 MHz on the coax, and a cable modem typically tops out at 1002 MHz (goCoax), so the two can share one cable. The same maker's cable-internet example shows a modem going to 1218 MHz, and some DOCSIS 3.1 modems go higher (goCoax). That reaches past 1125 MHz, so check your modem's upper frequency first, as the maker says. The MoCA standard itself covers a wider 400 to 1675 MHz (MoCA Alliance); the adapters here list the 1125 to 1675 MHz part (ScreenBeam).
With cable internet, the maker's setup puts a 2-way splitter between the MoCA adapter and the cable modem, and a filter just before the cable modem to separate the cable internet and MoCA signals (goCoax). The maker calls it a "PoE filter". It is a coax filter, not the Power over Ethernet of network switches.
Five checks before you buy
Satellite TV and standard MoCA cannot share one coax network: they overlap and interfere (goCoax). Every outlet and cable must be part of the same coax system (ScreenBeam). Every splitter on the path must pass MoCA signals from 1125 to 1675 MHz (goCoax).
If either of the first two checks fails, MoCA is the wrong tool. Try powerline adapters or a mesh system instead.
Mixing MoCA versions
The adapters here are backward compatible with MoCA 1.0, 1.1 and 2.0 (ScreenBeam). One maker warns that some older products use outdated MoCA technology that is not fully compliant with MoCA 2.5 devices (goCoax). Buying both adapters as a matched MoCA 2.5 pair avoids that.
Tips and tricks
- Read the frequency printed on each splitter between the two rooms. It should cover 1125 to 1675 MHz.
- Buy the adapters as a matched pair from one series, and read the Ethernet port line: 2.5GbE at both ends for a 2.5 Gbps link.
- With cable internet, fit the filter just before the cable modem, as the maker’s setup shows.
- Look up your cable modem’s upper frequency before you buy, as the maker suggests. Some DOCSIS 3.1 modems reach past the point where MoCA starts.
- If you have satellite TV on the coax, skip MoCA and use powerline or mesh Wi-Fi instead.
What we would do
We would check for satellite TV first and stop there if it shares the coax. Otherwise we would confirm both rooms have live outlets on the same coax system, read the frequency on every splitter in the path, and buy a matched MoCA 2.5 pair with 2.5GbE ports if the router and the device in the far room have 2.5G ports. With gigabit ports at either end, a gigabit-port pair gives the same 1 Gbps. With cable internet, we would add the filter before the modem.
Questions people ask
What is a MoCA adapter? A small box that sends Ethernet over the coax TV cable already in your walls. You need two: one cabled to the router and one by the TV, console or computer. A router or gateway with MoCA built in can be one of the two.
How fast is MoCA 2.5? The MoCA Alliance and the adapter makers list up to 2.5 Gbps. What you get is capped by each adapter’s Ethernet port: an adapter with a 10/100/1000 port tops out at 1 Gbps, and coax condition and noise bring the figure down.
Does MoCA work with cable internet on the same coax? Yes. Cable internet sits lower on the cable (typically up to 1002 MHz) and MoCA adapters use 1125 to 1675 MHz. One maker’s setup adds a filter just before the cable modem to keep the two apart, and says to check the modem’s upper frequency, since some DOCSIS 3.1 modems go to 1218 MHz or more.
Can I use MoCA with satellite TV? Not on the same coax. One maker says standard MoCA uses a range that overlaps satellite TV, and the two cannot work together on one coax network because of interference.
Sources
Each figure on this page is quoted from the source below or worked out from them. Sources checked , each quote read again against the source in a second pass.
- MoCA Alliance, MoCA Alliance: MoCA Home 2.5 page (operating range, speed):
MoCA technology delivers real world home networking speeds up to 2.5 Gbps.
mocalliance.org/moca-2-5/ - MoCA Alliance, MoCA Alliance: MoCA Home 2.5 page (coexistence):
The operating frequency range is 400MHz – 1675MHz.
mocalliance.org/moca-2-5/ - goCoax, goCoax MA2500D product page (US): key features:
MoCA2.5 over Coax Up to 5 channels bonded Up to 16 nodes in same network Up to 2.5Gbps real traffic throughput 1 x MoCA in port for Coax 1 x 2.5GbE RJ45 LAN
gocoax.com/ma2500d - goCoax, goCoax MA2500D product page (US): cable internet on the same coax:
The upper frequency limit of a cable modem is typically 1002MHz, and MoCA uses a frequency range of 1125-1675MHz.
gocoax.com/ma2500d - goCoax, goCoax MA2500D product page (US): higher modem frequencies:
Cable ISP, the upper frequency of cable modem is 1218MHz. Some DOCSIS3.1 modems have a higher upper frequency
gocoax.com/ma2500d - goCoax, goCoax MA2500D product page (US): splitter and filter at the cable modem:
Please install a 2-way splitter to connect MoCA adapter and cable modem. And just before the cable modem, please install a PoE filter to separate DOCSIS and MoCA signals in the same coaxial network.
gocoax.com/ma2500d - goCoax, goCoax MA2500D product page (US): splitters:
Ensure that all splitters are able to support MoCA and transmit MoCA signals in the frequency range of 1125-1675MHz.
gocoax.com/ma2500d - goCoax, goCoax MA2500D product page (US): satellite TV:
Standard MoCA networks use a frequency range known as the D-band, which unfortunately overlaps with the frequency range used by Satellite TV. As a result, normal MoCA and Satellite TV cannot operate together on the same coaxial network due to interference, which disrupts the signal.
gocoax.com/ma2500d - goCoax, goCoax MA2500D product page (US): older MoCA devices:
Some older products may use outdated MoCA technology that is not fully compliant with newer MoCA devices, such as MoCA 2.5 products.
gocoax.com/ma2500d - goCoax, goCoax MA2500D product page (US): fibre and other internet:
if you only need to use MoCA to connect your devices, it's much easier to use your home's existing coaxial cable wiring.
gocoax.com/ma2500d - ScreenBeam, ScreenBeam ECB7250 MoCA 2.5 adapter datasheet (PDF):
Extended D-band: 1125 ~ 1675MHz … up to 2.5 Gbps … 16 Devices (including NC) … One 10/100/2500 Base T 802.3bz … Backward Compatible with MoCA 1.0/1.1/2.0
screenbeam.com/wp-content/uploads/2025/04/ecb7250-datasheet.… - ScreenBeam, ScreenBeam ECB7250 datasheet (PDF): footnotes:
The throughput will vary based on the condition and noise found on the coaxial cabling within the home as well as the type of Ethernet Adapter supported on each computer or other device. … Coax outlets and Coaxial wiring must all be part of the same coax system. … A minimum of two ScreenBeam Coax Network Adapters are required to create a network, unless the user has a modem, router or gateway with MoCA 2.5 or below built in.
screenbeam.com/wp-content/uploads/2025/04/ecb7250-datasheet.… - ScreenBeam, ScreenBeam ECB6250 MoCA 2.5 adapter with 1 Gbps Ethernet datasheet (PDF):
ECB6250 delivers wired speeds up to 1 Gbps … up to 2.5 Gbps … One 10/100/1000 Base-T 802.3ab
screenbeam.com/wp-content/uploads/2025/04/ecb6250-datasheet.…