Will It Work? · Guide
Router placement: where to put your Wi-Fi router, how high, which way the antennas point
By Bulan Sarkar, founder of ElectronicsInfoline (since 2000)
The router usually ends up wherever the internet cable comes in: on the floor, in a cabinet, at the far end of the home. Moving it is free and often the first fix two makers suggest for weak Wi-Fi. This guide sets out where they say it should go, how high, which way the antennas should point, and when to add a second box instead. It quotes the makers' own support pages and gives no range figures, because they give none.
Put the router near the middle of the home, in the open, away from corners and outside walls, at about 1 to 1.5 ft (30 to 46 cm) on a table or shelf. Point the antennas straight up for one floor or tilt them to about 30° for several. Keep it out of cabinets and closets and away from microwave ovens and baby monitors. If one room is still weak, an extender goes about halfway between the router and that room.
Put it in the middle, in the open
A clear line of sight from the router to your devices gives the best signal, and the signal weakens as it passes through walls and other objects (NETGEAR). Both makers say to put the router as close to the middle as you can: one says the middle of the room, away from its corners, and to avoid rooms like a basement, attic or closet (NETGEAR); the other says a router against an outside wall leaves the far side of the home much weaker (TP-Link).
In a two-storey home, one maker recommends the middle of the first (ground) floor (NETGEAR). If the provider's cable comes in at one end of the home, a longer Ethernet cable from the modem or fibre box to the router lets you move the router without moving the line.
Height and antennas
One maker recommends a table or shelf at about 1 to 1.5 ft (30 to 46 cm), which puts the router's signal on the same level as most devices (TP-Link). Another says to raise it off the floor onto a shelf or table (NETGEAR). Home router antennas send the signal out sideways in every direction and weakly above and below, so do not use a device directly underneath the router (TP-Link).
An antenna pointing straight up sends its signal out horizontally, and one pointing sideways sends it up and down (NETGEAR). For one floor, point them straight up. For several floors, one maker suggests about 30° (TP-Link), and the other a mix of vertical, angled and horizontal (NETGEAR). One maker also advises against wall-mounting its fixed-antenna models, because that cuts the signal sent out horizontally (TP-Link).
What to keep it away from
Keep it out of cabinets, closets and cupboards. A cabinet blocks the signal (TP-Link), metal cabinets can block it entirely (NETGEAR), and small spaces can make the router overheat (NETGEAR).
Keep it away from the microwave oven and the baby monitor. They use the 2.4 GHz band too, as do garage door openers (NETGEAR), and one maker adds TVs and weak-current boxes to the list (TP-Link). If you have a cable modem, one maker says to keep other devices at least 3 ft (0.91 m) from it, because a few modems interfere with Wi-Fi (NETGEAR).
Keep it out of direct sunlight, which over time can damage the router and make it less stable (TP-Link). And skip the foil “reflectors”: one maker says they will not boost the signal and will scatter it and cause interference (NETGEAR).
Bands and walls
Each wall or ceiling weakens the signal, most of all walls with metal or dense material in them (TP-Link); concrete walls cut it a lot (TP-Link). The 5 GHz band is more sensitive to obstacles than 2.4 GHz (TP-Link), and a router using the 6 GHz band has to sit close to where you want that connection (NETGEAR). It is also normal for the speed to fall as you move away from the router (NETGEAR). The Wi-Fi bands guide explains the trade-off.
If the signal is fine but the connection is slow or drops, placement may not be the cause: the channel guide covers interference from nearby networks, and the Wi-Fi vs internet speed guide covers the plan itself.
Still weak: extender or mesh
For one weak room on the same floor, one maker suggests a range extender about halfway between the router and that room (TP-Link). In a 12 m example that is 6 m from the router. The other maker warns against putting an extender or mesh unit too far away (weaker signal) or too close (interference), and for a home too big for one router in the middle it suggests a mesh system (NETGEAR). The mesh, extender or access point guide sets out which fits your home, and the powerline and MoCA guides cover wired ways to reach a far room.
Tips and tricks
- Move the router before you buy anything: middle of the home, in the open, off the floor.
- Use a table or shelf at about 1 to 1.5 ft (30 to 46 cm), not the floor and not the top of a tall cupboard.
- Antennas straight up for one floor; about 30° for several.
- Take it out of the TV cabinet and away from the microwave and baby monitor.
- Do not sit the laptop directly under the router: the antennas are weakest straight below.
- Need the router elsewhere? Run a longer Ethernet cable from the modem or fibre box.
- For one weak room, put an extender about halfway to it; if the whole home is weak, look at mesh.
What we would do
We would move the router first: out of the cabinet, onto a shelf near the middle of the home, antennas up, with a longer Ethernet cable from the modem if needed. Only if one room stayed weak would we add an extender halfway to it, and for a large or multi-storey home we would look at mesh.
Questions people ask
Where is the best place to put a Wi-Fi router? As close to the middle of the home as you can, out in the open, off the floor and away from corners and outside walls. One maker recommends a height of about 1 to 1.5 ft (30 to 46 cm), level with most devices. Keep it out of cabinets, closets, basements and attics, and away from microwave ovens, baby monitors and TVs.
Should router antennas point up or sideways? Straight up for one floor. An antenna sends its signal at right angles to the way it points, so a vertical antenna covers the floor it is on. For several floors, one maker suggests tilting them to about 30 degrees; another suggests a mix of vertical, angled and horizontal.
Can I put my router in a cabinet or behind the TV? Both makers say no. A cabinet blocks the signal and reduces coverage, metal furniture can block it completely, and one maker adds that small spaces can make the router overheat. TVs are on one maker’s list of appliances to keep the router away from.
Is the router on the floor really a problem? Yes. One maker says to raise it off the floor onto a shelf or table; another gives about 1 to 1.5 ft (30 to 46 cm) so the signal sits level with phones and laptops. Do not use devices directly underneath it either: the antennas are weakest straight below.
Sources
Each figure on this page is quoted from the source below or worked out from them. Sources checked , each quote read again against the source in a second pass.
- TP-Link, TP-Link FAQ 455: router antenna position and placement:
Keep your router as close to the center of the room as possible to distribute the signal evenly. If your router is placed against an outside wall, the signal will be significantly weaker on the opposite side of your home. … We recommend a height of approximately 1 to 1.5ft, which places the router's signal on the same horizontal plane as most devices. … If you need to go upstairs or downstairs in your home, and the wireless needs to cover different floors, we suggest that you turn on the antenna at an Angle of 30°. … Keep the router away from microwave ovens, televisions, weak current boxes, and similar devices. … Placing the router inside a cabinet blocks the signal and reduces overall coverage. … concrete walls in particular significantly reduce signal strength. … Prolonged exposure to direct sunlight can damage the device and reduce both stability and network performance. … For the AX11000 and other products with fixed antennas, wall mounting is not recommended as it reduces signal transmission in the horizontal direction.
tp-link.com/us/support/faq/455/ - TP-Link, TP-Link FAQ 468: improve Wi-Fi signal and range:
For wireless devices operating on the 5 GHz band, the signal is more sensitive to obstacles. … They radiate horizontally in all directions, but produce a weaker signal above and below the antenna … Because antennas transmit weakly at the base, do not place your wireless client device directly below a TP-Link wireless router or access point. … Each wall or ceiling reduces Wi-Fi signal strength, particularly those containing metal or dense materials. … Place it about halfway between your router and the area with a poor signal to extend coverage precisely where you need it.
tp-link.com/us/support/faq/468/ - NETGEAR, NETGEAR KB 25182: poor wireless range or a weak WiFi signal:
it’s normal for your speeds to decrease as your move away from your router … A clear line of sight from your router to your devices provides the best WiFi signal. The signal strength decreases as it passes through walls and other objects; some objects, like metal cabinets, might block the signal entirely. … Install the router as close to the center of the room as possible, away from the corners of the room. We recommend that you avoid placing your router in rooms like a basement, attic, or closet, and avoid other devices that might cause interference, like microwave ovens or baby monitors. Because of the 6 GHz band’s shorter range, WiFi 6E routers must be positioned close to where you require the high-speed 6 GHz connection. … an antenna pointing vertically projects a WiFi signal horizontally, while an antenna pointing horizontally projects a WiFi signal vertically.
kb.netgear.com/25182/ - NETGEAR, NETGEAR KB 000037824: what can affect WiFi performance:
Many WiFi-enabled technologies and other household devices use the 2.4 GHz band, including microwaves, garage door openers, and baby monitors. Some WiFi devices like smart speakers also use the 2.4 GHz band to transfer real-time audio. When multiple devices attempt to use the same radio space, overcrowding occurs. … If you and your neighbors have the same Internet service provider (ISP), you might share bandwidth with them. If you share bandwidth with your neighbors, you might experience slower Internet speeds after work hours … While uncommon, some cable modems can interfere with other WiFi devices. To prevent interference, make sure that other devices are at least three feet away from your cable modem.
kb.netgear.com/000037824/ - NETGEAR, NETGEAR article: best router placement (updated 24 Aug 2026):
Elevate the router off the floor on a shelf or table for better range. … Position the router centrally on the first floor in two-story homes for best performance. … Don’t hide the router in a closet, cabinet or cupboard as it reduces wireless router signal strength. Small spaces can also lead to overheating. … Those trendy DIY “WiFi reflectors” popping up on social media won’t boost your WiFi—they’ll just scatter your signal and cause interference. … If central router positioning isn’t possible or the space is too large to cover – consider a WiFi Mesh system to seamlessly cover more space. … When using a Mesh Satellite or WiFi Extender, avoid placing them too far away (weaker signals), or too close together (causing interference).
netgear.com/hub/wifi/routers/best-wifi-router-location/